Banner bug in edit mode

Hello,

I noticed that while adding to the banner stack, moderate amounts of content will get cutoff in edit mode and cannot get to the contents placed at the bottom. I.e. I am unable to scroll within the banner stack. I hope this makes sense.

Also, I would like to position the content either left or right. It currently will only allow center position. Any recommendations? Perhaps a different stack?

Thanks

There’s a workaround/solution described in this thread that you can try: Banner stack in edit mode

You can make the contents of the Banner go edge-to-edge by setting the Inner Container setting to Fluid and then enable Remove Left & Right Padding.